Carabineer Canisters
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Redesigned the body around a carabineer loop for storage on a climbing rack.
- Rating
- 0 / 5
- Likes
- 44
- Downloads
- 90
- Makes
- 0
- Views
- 1,492
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I have 3 sizes here. The 120x30mm and 120x80mm large sizes. I found that the original lids were pretty thick and could be scaled down in height at the slicer, otherwise it's pretty bulky.
The third size is the 80x80mm. Again, I scaled down the lids a little bit at the slicer, but those aren't included here. Just the body.
For both bodies, I set up supports to kick in below 30 degrees so that it wouldn't try to support the bevel, just the loop sticking off the side. Because these things will be hanging and holding tool bits and such, I beefed the walls up slightly, but that's about it. I also tried to leave the geometry semi-accessible so something free like Blender would let you go in and adjust final height and where on the canister the loop is located.