Bondtech LGX Lite PRO Picobilical Stabilizer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mashup of the Bondtech LGX Lite mounting plate with the mounting plate required by the LDO Voron v0.2 Picobilical PCB.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 63
- Makes
- 0
- Views
- 347
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Public Domain
I used PCBWay to get a black glass fiber nylon (PA-12+35% GF) part printed that is near identical to the original kit part in finish. jlcpcb was able to make the part for much cheaper but the quality wasn't as good - it would have been fine but at the point one is putting one of these extruders on a printer it's worth going a bit overkill :)
Both shops complained about some of the clearances and I tried both with/without their suggested modifications but it didn't seem needed as both printed fine.
The risers included in the Bondtech kit can be used directly as the distance from the extruder to the mounting plate is the same as the original. If not using the kit then the ones included with the LDO Voron v0.2 kit can be used with some additional 0.5mm washers. The original PCB spacers from the Picobilical can also be used though one smaller bolt will be needed as the depth was changed for clearance.