1 / 2
IR Turret Nerf Dart (no rubber band)- CrunchLabs Hack Pack 001
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fully 3d printed ammunition IR Turret (CrunchLabs Hack Pack 001)
- Rating
- 0 / 5
- Likes
- 22
- Downloads
- 133
- Makes
- 0
- Views
- 1,842
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
IR Turret Nerf Dart - Crunch Labs Hack Pack 001
Overview
This is 3D-printed replacement ammunition. No rubber band is required. The spring is 3D-printed.
3D Printing Info
- Print Time: Approximately 30 min on Prusa MK4
- Material: PLA/PETG
- Supports: Yes
- Infill: 20%
- Layer Height: 0.2 mm
- Perimeters: Default
Notes
- I add a slight bend to the circle at the end of the spring (notches on the shooting end). This makes it easier to latch on.
- I adjusted the design to minimize supports but this means the fins are shorter than the original.
- The circle/latch is at the edge of the nerf bullet vs. the center. If it was placed at the center, it wouldn't fire straight.
- Unsure how the spring will hold up. I'd recommend not keeping loaded on the turret when not in use to reduce wear.
Updates
- 5/27/2024 added stronger spring to go ~3x farther (v2)
- 5/27/2024 hollowed center of cylinder to improve aerodynamics