ikea översidan for Prusa enclosure

You'll need to print one kit without cutout (left side) and one with cutout (right side - for PTFE tube)

additional parts:

• screw M3 x 12mm → 3 x
  • 2 x for the mounting kit itself
  • 1 x for enclosure 
• screw M3 x 16mm → 1 x
• screw M3 x 30mm → 1x (optional for adustment)
• nut M3 → 3 x 

assembly:

step 1:

• base part (either w/ or w/o cutout)
• clamp
• M3 x 12mm
• M3 nut

Use the left holes. Do not tighten to much as it should easily move

step 2:

remove the support by carfully turning the joint

step 3

use the parts from step 1 and step 2 and one M3 x 12mm crew plus M3 nut

step 4

you need the previous assembly plus M3 x 16 with nut

step 5 (optional)

M3 x 30 for adjusment. There is no thread as the screw will cut it. 

install

possible holes for installing with M3 x 12 screw.

final