Icom ID-5100 controller head speaker mounting bracket

For some time, I'd used a pair of zip ties to keep the SP-35 speaker attached to the suction cup mount for the Icom ID-5100 controller head, but this 3d printed bracket is a sturdier (and tidier!) solution.

You will need:

• The Icom ID-5100 (may worth with other radios, but I don't have any others to test)
• The Icom MBA-2 magnetic mounting bracket, which should have come with the radio
• The Icom MBF-1 suction cup
• The Icom SP-35 speaker (again, may work with other Icom speakers; I don't know if the mounting hole pattern differs)
• The printed parts - one copy of ‘ID-5100 Speaker Mount’, and two of 'ID-5100 Speaker Mount Plastic Washer)
• Six M3 screws; six M3 nuts; two M3 washers

Assembly instructions:

• Push the M3 nuts into the recesses in the bracket
• Seat the controller head side of the ball mount adapter from the MBF-1 suction cup mount into the circle cut-out
• Attach the MBA-2 magnetic mount to the other side of the 3d printed bracket, and tighten the MBF-1's ball mount adapter to keep the MBA-2 in place
• Screw four M3 screws through the holes in the MBA-2 into the four nuts placed at the corners of the 3d printed bracket
• Using the two remaining M3 screws, two M3 washers and the two 3d printed plastic washers, attach the SP-30 bracket to the other face of the 3d printed bracket

The printed parts in the photos were sliced in SuperSlicer, and printed using eSUN PETG with a 0.3mm layer height on a Prusa MK3s+ running Klipper.

December 2022 update: Over the course of a year the PETG print deformed significantly, presumably due to creepage from the weight of the speaker hanging from the printed part.  I've since reprinted it in ASA.