City Car

Beep Beep! Cute “City Car” that lets your imagination roll! 

Original design for the 2024 Christmas Community Print Drive.

The “City Car” prints on its side with no supports. The wheels are NOT able to turn to maintain durability for the print drive. (Rolling City Car on Cults3D.) Print with one color, a fun filament, or with a couple swaps at key heights for a more detailed look. See notes in Print Settings below.

The smaller “City Car 40” is large enough for print drive standards. Print more!

For the larger City Car 60, use the included test model to check whether your printer can handle the long bridging for the windows and doors. If not, print the “Outline” version of the City Car 60. This one has much easier bridging and should work fine with most printers.

Check out my “Flatbed Truck” and “City Bus” too!

More Models: Collection of all approved 2024 Christmas Community Print Drive models

Additional Information and Print Settings

"City Car 40" is approximately 67 x 45 x 40 mm. “City Car 60” is approximately 101 x 67 x 60 mm. I printed with 0.25 mm layer height, 3 perimeters, 3 top and bottom layers, and 15% rectilinear infill. For printing with the side stripes, set filament swaps after the heights as listed below.

City Car 60: 8 mm and 52 mm.
City Car 40: Approximately 5.33 mm and 34.67 mm, depending on slicer and layer height.

No supports. No raft.

More of my designs on Cults3D: https://cults3d.com/en/users/abbymath

Not for commercial use. No derivatives. See license below.