Challenge Coin Display
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Semi-modular Challenge Coin Display that can increase or decrease coins as needed.
- Rating
- 5 / 5
- Likes
- 80
- Downloads
- 395
- Makes
- 2
- Views
- 3,184
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
Needed a coin display and was unimpressed by the ones on Amazon (and the price).. so i made this, this is version 2, the first was thinner and didn't include a good way to connect the pieces.
They are setup with a Top and Bottom at a minimum. There is a middle piece that can be printed as many times as needed to fit your coins. I have included a small coin/trinket display as well that wouldn't otherwise fit in the holder.
I've included a small keyhole for hanging on the ‘Top’ piece, 10mm deep. Was originally designed around a standard push pin, but I'm sure will work with various screws/nails.
The pieces fit together with a friction fit, unsure how this will last, a small dab of glue I'm sure won't hurt none if you feel it is loose.
Printed on a Creality K1.
.4mm nozzle
.2 Layer height.
10% infill
4 walls
Standard PLA.
The ‘Top/Middle/Bottom’ pieces are printed flat, though printing at a slight angle may help the coin ‘pegs’ have some strength, when removing supports, be careful not to put too much force on them. The small coin bracket was printed so that it sits upright, how it would be placed on the display.