1 / 3
JOINT travel/transport CASE // labeled *high* // "print-in-place-model"
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Optimized Version! // bit Longer // bit more inner-width for active tubes
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 280
- Makes
- 2
- Views
- 877
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hi,
I tested a lot available models and got improvement ideas for all of them, by some friends ;D.
The ideas are:
- cooler chilled Design
- more perfect click-effect of the cover for a closing-enjoyment
- long enough to not stress the joint
- more width to get the joint out without getting any stress-levels
print settings:
- 0,15mm layer (0,4mm nozzle)
- 3 perimeters
- 15% infill
- supports and brim can be used as follows

Important: no supports or brim in the "joint-area" :D - (marked red)
Happy chilled printing!