Spool drill winder - No screw - Any width - Lightweight - Quick print - Printable Hex Bit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Spool winder for any hub in the range 50-55mm. Any width, even smaller minispools. Lightweight, only 50-60g.
- Rating
- 5 / 5
- Likes
- 56
- Downloads
- 376
- Makes
- 4
- Views
- 1,241
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
Maturity: Very good.
10 prototypes.
In use since 2024/06.
A spoolwinder easy an fast to mount on a drill. There is no screw. It fits an 6mm hex bit.
The spool winder is for any spool hub in the range 50-55mm.
Choose the spoolwinder with an hex size fitting your bit. Personally, my last choice is a 6.2mm hex hole (MoyeuRembobineur-r02g - L100-Hx6.2)
I found annoying to search for the proper hex bit each time. Then I decided to print one that stay in place in the spoolwinder. Print the one that fits best in yours. 5.70mm to 6.50mm available. For a 6.2mm hex bore, I choose a 5.85mm hex bit.
Printing advise:
Layer height 0.3 is enough. But 0.2 has a better smooth entry.
Lighting infill or no infill is enough for the spool winder.
Hex bit is better with 3 perimeters or more.
PLA is good enough.
Nozzle 0.4 or 0.6.
There is two configurations. “With pads” and “Without pads”. Take the “With pads” configuration if you fear you may have bed adhesion issues on small areas or as an insurance.
Log:
2024/06/15: Initial release
2024/10/01: Printable Hex bit added.
2026/03/27: More Hex bit sizes added.
2026/03/28: Sizes for Hex hole of the spoolwinder. Spiral arms width 1.7->2.0mm as some plastics have low modulus.