Economical modular drawers with 1L volume each

Modular drawers, inspired by https://www.printables.com/model/72750-modular-organizer-drawers-alternative-design/files, but with all-new models of outer boxes and increased volume of drawers with a lot of changes and improvements.

I tried to find a way to shorten time of printing with less amount of material, but with good toughness. After couple designs I found good shapes, what presented in this version.

60g/2:30hrs for box (with 15mm^3 volume speed)

65-101g/1:40-2:30hrs for drawers (depends on amount of cells inside drawer, with 15mm^3 volume speed)

Recommendation for printing:

0.2 layer, 10-15% infill, 2walls, dynamic walls / Arachne (in Orca slicer), material - PLA/PETG

PS: connectors not very strong against lateral breakage. Be carefull, when removing from the table. But more than enough stiffness, when you put it to the place.

PPS: The whole elements of the project should assemble without glue and stick together fine.

PPPS: Later I will add upper closed part for box. Stay tuned for updates

WARNING. On boxes that do not have a crossbar, the side walls in the middle diverge slightly in width, which makes the box dense. I did not want to add stiffeners to the inside of the box, but it is fixed simply by bending the side walls inward. The geometry of the model remains correct, as intended.