Backpack can holder

I've made a foldable can holder. I'ts HERE

I felt like I had to make this, and I'm not disappointed.

This is made to hold your soda can on your backpack strap or any other place you'll manage to attach it too.

My print settings:

• PETG
• 4 walls
• 20 per cent infill
• no supports
• 0.2 layer height
• mouse ears

Get rubber bands too, as well as glue.

You'll have to print one version of the can holder and two rings.

Witch models you should print depends on the way you want to attach the holder.

I've planed for a few options :

1. Mounting it on a plain backpack strap, with no preexisting attachment points.

In this situation, “can holder naked” is best, accompanied by two “ring with hooks”

Wrap rubber bands around the strap and hook them SECURELY to the rings.

     2. Mounting it on a backpack strap that has molle type webbing :

In this situation, "Can holder with glue tab" comes in, accompanied by it's optional “molle tab to glue” and “QUICK CLIP to glue”. Both remixed from QUICK-CLIP.

“Horizontal strap clip to glue” is also available.

The clip itself comes from HERE

Use the tab that suits your needs best, and print either two “ring with hooks” or just one for the bottom and "ring" for the top.

     3. Mounting it somewhere that has an horizontal molle strap

In this situation, “can holder with strap clip” comes in, accompanied, once again, by either two “ring with hooks” or just one for the bottom and "ring" for the top.

The clip itself comes from HERE

Please remix my system for your specific needs.

There is potential to turn this into a base plate for a water bottle too.

Please share photos of your can holder on your favorite bag once it's printed, accompanied by memories from the crazy adventures it went on.