Target Gallery

These are the parts I designed and used to build the Polymaker Target Gallery.  These are all STEP files to allow remix or adjustments as needed though they worked well at both events.
This is a starting point to build from.
You will need Arduino Nano, RJ45 module, LED, MG90 180 degree analog servo with mechanical stop. two brass tacks and two 1K ohm resistors
A variety of screws were used to assemble M1.2x6 (Nano), M1.7x6 (servo motor),M2x6 (RJ45 & cover), M2x8 (Servo mount), #4x1/2" (target hinge mount)
Wire from a marking flag is used to connect the target to the target hinge.
LED has 1K ohm resistor soldered to anode then connects D2 of Nano, cathode to ground
One brass tack has wire soldered and connected to 5V pin of Nano
Other brass tack has wire and 1K ohm resistor soldered to it then a wire soldered to end of resistor.  Wire top of resistor connects to D4 of Nano, Wire bottom of resistor goes to ground.
Servo connects to its own 5V and ground then control wire to D3 of Nano.

You will have to assemble a harness (not complicated) for connection from RJ 45 module to base.  Dupont wires from Arduino kit will work.

If you have any question feel free to contact me here or on X(Twitter) or Discord as there is a bit more to the build. I'm sure I've forgotten a few things…