Shark Vacuum Mount with Integrated Cable Clip and Accessory Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Strong mount system for a Shark Cordless Stick Vacuum (IZ202UK), although should fit other Shark cordless vacuums too.
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 361
- Makes
- 0
- Views
- 1,857
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
Strong mount system for a Shark Cordless Stick Vacuum (IZ202UK), although should fit other Shark cordless vacuums too with similar handles.
There are 3 integrated cable clips to manage the charging cable and position it at the top where the charge port is on the vacuum as well as a single holder for an accessory, made to fit the straight hose attachment.
It also comes with 3 holes set and positioned to be attached to the wall with 3 screws so as long as the wall is strong enough, the vacuum can be mounted in a hanging position.
I printed mine with 25% infill, with the flat side to the bottom and with supports enabled and limited to 10 degrees (Overhang threshold). You want supports for the main overhanging bracket but shouldn't need any for the accessory holder which is why I limited mine to 10 degrees.
EDIT
After printing and fixing mine, if you want it completely hanging (as I did) it could do with a fair bit more infill, maybe even as much as 50%. It works fine but I imagine after a bit of use it might eventually fail.
I also mounted it at a very slight angle so the vacuum isn't tempted to slide off.