1 / 1
top_gun_de's "Voron V2.4 and Trident: Y Endstop Relocation" adding a 2-pin JST XH connector
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of top_gun_de's Y endstop relocation modified to add a 2-pin JST XH connector.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 98
- Makes
- 0
- Views
- 841
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Assembly (from original with some additions):
- Solder wires to the endstop. Use the two outer pins, don't connect anything to the inner one. If you are unsure about this, check the V2.4/Trident manual, there are instructions for the wiring of the x and y endstop switches. No changes on that procedure.
- Optional: Use a small piece of heat shrink over the middle pin
- Use 2 M2x10 self-tapping screws to fasten the microswitch in the bracket.
- Push the 2 pin XH connector from the outside into the bracket.
- Optional: Use a small dab of super glue if needed to fasten the connector
- Turn out the two front screws for the stepper motor, use M3x35 to attach the bracket. The holes are actually slots for endstop adjustment. I get good results when the bracket is flush with the motor housing.
- Fasten the bumper to the gantry, use the holes and screws that you used for your cable bridge. The mount was designed for the stock screws.
- Connect the male 2 pin connector and run wires to your MCU.