1 / 2
3 Inch Netcup
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needed a 3 Inch deep netcup to fit perfectly into a downspout NFT setup. So ka-blam!
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 22
- Makes
- 0
- Views
- 168
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3 inch deep netcup that was remixed from a 2 inch deep creation.
I print these on a RAFT just in case. By all means you do not need to do so if your print surface adheres well to filament.
I print with any range of layer thickness from .2 to .3.
Infill I have printed with 5-20%
I print these bottom down and the rim does not need support. You might get some excess filament dangling off the rim. just snip it off.
Usually takes 2 hrs to print 1.
Questions or comments please ask.
Thank you