1 / 7
MGN9 Voron Toolhead Display Stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple toolhead display stand for Voron, Micron that use MGN9H or MGN9C like Dragonburner, Yavoth, Wth burner
- Rating
- 4 / 5
- Likes
- 22
- Downloads
- 82
- Makes
- 0
- Views
- 931
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Show off your favorite toolheads! Put them on your desk as decoration with this is simple stand with MGN9H and MGN9C mounting pattern.
Hardware:
- 4x heat-inserts - “voron spec” 3ID*5OD*4H
Note:
Make sure outer edges are flat after adding heat inserts, use exacto knife if necessary, as heat-inserts could push plastic out a little bit.
Compatible toolheads:
- DragonBurner with MGN9H mount
- Yavoth same as above
- MiniSB
- WTH Burner with micron mount
almost any toolhead with MGN9H or MGN9C mount pattern should work.