Big-bait model SWIMER big lure
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.16 – €3.86 net (excluding VAT)
For file: swimer_0.4n_0.2mm_PLA_MK4IS_3h2m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.51 excluding VAT (range midpoint).
- Weight reported by the author
- 54 g
- Print time reported by the author
- 3.03 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Pre-jointed large lure
- Rating
- 0 / 5
- Likes
- 85
- Downloads
- 471
- Makes
- 0
- Views
- 1,966
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Overall length: 230mm
Please model the lure vertically.
It is already jointed, so please model it as is.
There is a weight room in the width section. Use M3 nuts and M3 screws.
The dorsal fin and tail fin should be modeled with TPU.
Dorsal fin: Insert it by sliding it in from the back.
Tail fin: Insert it by pushing it in from the back.
It requires a lot of force, so please use pliers or other tools to assist.
This design is intended to prevent the fins from coming loose.
Approximately 35g of weight is needed.
Enjoy using this SWIMER.
Print settings:
- I printed it with Bambu Lab P1S
- Layer hight: 0,2 mm
- Infill density 20 % (Grid)
- Wall loops: 3
- Manuel support
- Material: Esun PLA +