Thrust Ring for 29mm Estes Model Rocket Motors/Engines
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple, small part designed to make launch life easier
- Rating
- 5 / 5
- Likes
- 24
- Downloads
- 65
- Makes
- 1
- Views
- 428
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
This is a simple thrust ring, designed to slip onto the end of an Estes 29mm motor. I don't normally fly Estes BP motors, but when I do, I have to use the tape method because I do not put thrust rings in my motor mount tubes. Ever.
This prints in under 15 minutes for most printers. It is a tight fit, so be patient when slipping it on. If you find it too tight, run some sandpaper on the inside of the ring. Once in place, apply a little thin CA glue to the top.
It is intended to be a single-use item and it is intended for use with a retainer ring and cap (like on the Extreme Series Model Accessories)
If you find this useful, please post a make and a comment. Also, please like this model. It really helps me. Thank you!