Thrust Ring for 29mm Estes Model Rocket Motors/Engines
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple, small part designed to make launch life easier
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 65
- Wydruki
- 1
- Wyświetlenia
- 428
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple thrust ring, designed to slip onto the end of an Estes 29mm motor. I don't normally fly Estes BP motors, but when I do, I have to use the tape method because I do not put thrust rings in my motor mount tubes. Ever.
This prints in under 15 minutes for most printers. It is a tight fit, so be patient when slipping it on. If you find it too tight, run some sandpaper on the inside of the ring. Once in place, apply a little thin CA glue to the top.
It is intended to be a single-use item and it is intended for use with a retainer ring and cap (like on the Extreme Series Model Accessories)
If you find this useful, please post a make and a comment. Also, please like this model. It really helps me. Thank you!