Flush Mount USB Holder
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.37 – €0.45 net (excluding VAT)
For file: flushmount_usb_holder_1in_0.2mm_PLA_MINI_28m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.41 excluding VAT (range midpoint).
- Weight reported by the author
- 4 g
- Print time reported by the author
- 27.6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a flush mount USB holder I designed for my Ikea Lack enclosure.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 56
- Makes
- 1
- Views
- 817
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
This is a flush mount USB holder I designed for my Ikea Lack enclosure. I use two small USB drives for gcode and they can be easily misplaced. Now, they have an official spot on my Ikea Lack enclosure.
Assembly:
- Drill a 1 inch (25.4 mm) hole into the desired surface at a minimum depth of ½ inch (~12 mm) If drilling into an Ikea Lack Enclosure, be very careful as the table is mostly hollow. I used a hand turned 1" auger bit and brace to cut a clean hole.
- Apply CA glue to the inside rim of the USB holder and press the holder into the hole.
- Double check that the part is in the desired orientation before the glue has time to set.