1 / 5
Sky-Watcher - Star Adventurer GTi - Control Knob Tool
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A tool to make using the Azimuth Control Knobs much more enjoyable on a Star Adventurer GTi.
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 71
- Makes
- 1
- Views
- 446
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Public Domain
A simple device that slips over the existing knobs for Azimuth (also fits the RA clutch knob, sorta) and gives a better feel and more control. Intended as a tool shared between the knobs, but could be installed permanently if you want (I don't recommend, but you do you). There's a bit of variance in the oem knobs so it may not fit well for you. Provided 3 slightly different diameters.
Print Settings:
- 30% infill (could go lower, shaft is limitation and could probably survive at 15%)
- Cubic Infill, or other off-axis infill like Gyroid. Hex would probably be fine, too.
- No supports needed
- PETG Recommended for these versions, PLA might need different sizing for shrinkage/lack of.
- Knob part should be on build plate, opening up top.