Auxiliary fan mount for Flashforge adventurer 5m
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adaptation of FYSETC voron trident 12032 side fan mount for Flashforge adventurer 5m.
- Rating
- 5 / 5
- Likes
- 175
- Downloads
- 608
- Makes
- 1
- Views
- 8,825
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
You will need 12032 fan (basically 4 pin, but also you can use 2pin with config edit), some nuts and screws to attach fan.
I mounted the fan with a double sided tape. The only tricky part is to mount upper part. It must be about 1.5 mm just under printhead. So it need to be aligned with tape or some spacers.
Consists of two parts: upper and bottom. On top part you will need to remove some ribs. I left them from original model. Look like they act like a support.
Prints without supports.
In Klipper [i use klipper mod] defined as Chamber fan:
config for 2 pin:
[fan_generic chamber_fan]
pin:PC6
hardware_pwm:True
enable_pin:PC7
for 4 pin:
[fan_generic chamber_fan]
pin:PC7