Sunlu S2 Bowden tangent passthrough + guide
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bowden passthrough (remix) for the Sunlu S2 filament dryer, + guide for feeding the filament straight down (original)
- Rating
- 0 / 5
- Likes
- 28
- Downloads
- 165
- Makes
- 0
- Views
- 798
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A minimalist filament passthrough and guide for the Sunlu S2 filament dryer that doesnt require drilling, screwing or gluing. This little adapter wil just slide in and friction fit. Accepts a short (~10cm) length of 4mm OD PTFE/capricorn tube. Remove the factory tube insert first.
Tube can exit either near-vertical or near-horizontal. If the latter, and the spool is mounted above the printer, the guide part can be printed and attached to the outside of the S2 as shown. Without the guide, the PTFE tube may kink.