1 / 2
Associated Spur 32P 64T (GT2 Slipper)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is what a Team Associated GT2 32P 64T spur gear would look like if it existed.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 93
- Makes
- 0
- Views
- 516
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
This is what a Team Associated GT2 32P 64T spur gear would look like if it existed.
I ran a 56T (ASC7957) but needed a bigger one so i made one using Fusion 360.
This is HALF of it, print it twice and then use the 3 holes to screw some M3 in for alignment and glue both halves together using thin CA glue or something similar. Then remove the screws.
- Tolerances should be pretty close but it's best to drill the center hole cleanly using a 5mm drill bit before use.
- DON'T use a brim, you will never be able to remove it cleanly from the teeth.
- If your slicer supports it, use a small negative "Initial Layer Horizontal Expansion" to compensate the "elephants foot" effect of the first layer getting squished. I use (-0.16mm).
UPDATE : I've ran this spur for 6 hours total now, no sign of failure anywhere ! Looks like eSun PLA+ is great for gears !
Print instructions
Category: R/C Vehicles