Ikea Lack adjustable feet for shortened legs
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Create every height for Ikea Lack tables with these adjustable feet that fit firmly over legs that are cut to length.
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 64
- Makes
- 1
- Views
- 370
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
For a 3D printer table I wanted to use 2 Ikea Lack 50x50 tables. 2 times 45cm height would be a bit too much, so I shortened the legs of the bottom one of the two tables. In order to regain stability and for leveling the setup, I designed these feet that firmly fit over and in the cut off legs.
The design uses a 30mm threaded screw with a 3mm pitch to adjust the height, so one full turn changes the height 3mm. Total adjustability is approx. 0 - 25mm. There's also a spanner to make adjusting a bit easier.
Update 25-07-2024: I added some covers that I put over the feet, printed in TPU. TPU is a bit softer than regular filaments and therefore probably better on a wooden floor. At least that's what I hope…