Ikea Lack adjustable feet for shortened legs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Create every height for Ikea Lack tables with these adjustable feet that fit firmly over legs that are cut to length.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 64
- Wydruki
- 1
- Wyświetlenia
- 369
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
For a 3D printer table I wanted to use 2 Ikea Lack 50x50 tables. 2 times 45cm height would be a bit too much, so I shortened the legs of the bottom one of the two tables. In order to regain stability and for leveling the setup, I designed these feet that firmly fit over and in the cut off legs.
The design uses a 30mm threaded screw with a 3mm pitch to adjust the height, so one full turn changes the height 3mm. Total adjustability is approx. 0 - 25mm. There's also a spanner to make adjusting a bit easier.
Update 25-07-2024: I added some covers that I put over the feet, printed in TPU. TPU is a bit softer than regular filaments and therefore probably better on a wooden floor. At least that's what I hope…