Rode PSA-1 Clamp & Bolt
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is my own design for a replacement of the Rode PSA-1 clamp. Highly recommend a strong filament like PC or ABS-GF.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 21
- Makes
- 0
- Views
- 207
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my own design for a replacement of the Rode PSA-1 clamp. I highly recommend printing this with strong filament. I used Inland Tough PC filament for the clamp itself.
The bolt itself doesn't need any special filament as long as it isn't over tightened. Inland PLA Tough was the filament I used for my bolt & it only ever broke at the knob, which was caused by over-tightening.
Please do not underestimate how strong this part needs to be.
Print settings:
Clamp:
- Walls: 5-7
- Cubic infill 35%-50%
Bolt:
- Walls: 4-6 (this is important for the grip)
- Cubic infill 40%-50% (Just make sure the bolt part itself is a solid piece)
- Bottom/Top Surface pattern: Concentric
- Internal solid infill pattern: Concentric
Bolt pad:
- Walls: 3
- Cubic infill 25%-35%
- Bottom/Top surface pattern: Concentric
- Internal solid infill pattern: Concentric
Print the part laying flat on its side. Depending on your part cooling capability, you may need to add support to the rounded corners coming off the build surface.