3010 / 3007 Fan Cable Cover for Galileo 2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Galileo 2 toolhead door with non-interfering 3010 or 3007 fan mount, from JaredC01's official part for compatibility.
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 137
- Makes
- 3
- Views
- 698
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I believe this design avoids some of the issues that are present in other Galileo 2 compatible board-fan mods. Features of this one are:
- True to Original: Started with JaredC01's official CAD file, and attempted to make the fewest, cleanest changes required to mount the fan.
- Maintains Interior Space: Does not press the fan against board capacitors as some other fan mods have.
- Minimalist: Fan placed against the (former) inside wall of the cover to minimize impact on size. Fan mount arms are small and lower mass than the plastic removed. So mass of this door (without the fan) is slightly less than the original part.
- Works Well with PG07 CAN Bus mount: See: https://www.printables.com/model/950393-galileo-2-webb-sb2209-inline-pg07-cable-support-ca
Please use the affiliate links below for any supplies you may need for this. Design, testing, prototype prints and refinement amounted to hours of work, and I will certainly do more of this if it ever starts paying off. :-)
Regarding Locktite: This is a rare case where you should not use Loctite. These screws get a lot of stress/use. And Locktite increases the force on the heat set inserts and will hasten them working their way out of the plastic. It is for this reason that I recommend the weak stuff for use in 3D printers overall, such as Loctite 222, 6ml: https://amzn.to/3zpIShE or 50ml: https://amzn.to/3L7HHG2. But it is not really needed on these two screws, so I'd leave it off.
BOM:
- 1@3010 Fan. In this size, dual bearing is best: https://amzn.to/3Whtpb5
- 1@M3x20mm SHCS screw. Use existing or get a kit: https://amzn.to/3zxFgtM
- 1@M3x6 FHCS screw: Use existing or get a kit: https://amzn.to/3SgCi3B
- Filament (Recommend ABS for build chamber temperatures): https://amzn.to/3Yei4ew
INSTRUCTIONS:
- (Optional) Shorten the fan wire to the length needed for your use case.
- Put the fan wires through from the outside of the cable cover / door.
- Orient the fan so the wires exiting the fan are on top (toward the hinge-screw hole), and the label side of the fan is facing in.
- Press the fan halfway into the fan mount.
- Make sure the fan wires are in the small cutout for them on the top side of the fan hole.
- Press the fan the rest of the way in, being careful not to pinch the wires, until is seats completely.