Electrical Connector Crimper Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lockable case to store crimper and extra jaws.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 72
- Makes
- 0
- Views
- 374
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Thank you to @TheSameNameTwice for the original model for the case. Refer to his model for printing and assembly instructions. I used PLA for the top and bottom, and ABS for printing the smaller parts for durability. However, I think PETG would be fine for this as well. For the pins, I would recommend using ABS from a quick test I found that PETG seemed to kind of kink a bit. I did not try PLA, but I imagine it would be too brittle for this application.
This case is designed for this kind type of crimper:
and some of the jaws. It can fit 4 small jaws (32-33mm long) and 2 medium jaws (37mm). If stored in the crimper, it can also fit one larger set of jaws (40mm). The crimper does not fit with very large jaws like the H5 (44mm) in it.
From the set I have I can say the following
32-33mm: 103, 10A, 10WF, MC4, 03B
37mm: 1035WF, 40J
40mm: 06WF2C
This link shows the jaws and their part numbers: