MPLAB-SNAP (MicroChip PG164100)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a low quality 3D model of the MPLAB-SNAP (MicroChip PG164100) in circuit debugger for fit purposes.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 101
- Makes
- 0
- Views
- 393
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This is a low quality model of the MPLAB-SNAP (MicroChip PG164100) debugger. I made it because I 3D print “debugging platforms” for my projects which hold my boards, cables, debuggers, etc.. MPLAB-SNAP is a little weird because of the female connector so I like to connect it directly to a header on the project board but I want to protect it from moving around. It is not intended to be printed but to be used in order to size/position the MPLAB-SNAP in a 3D printed project. I made it with Kicad because that was easiest. Note that the schematic and PCB are just a means to an end.