1 / 4
IKEA Table Foot Extension | 50mm ⌀ Furniture Leg Raiser — image 1
1 / 4

IKEA Table Foot Extension | 50mm ⌀ Furniture Leg Raiser

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Extend the height of 50mm IKEA table feet with 48mm inner diameter. Various heights in 5mm increments available

Rating
5 / 5
Likes
12
Downloads
66
Makes
1
Views
471
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Extend the height of IKEA tables with 50mm diameter feet.

Remixed from Ikea Table foot endcap by Joshi. 
That original model raises the metal feet by 5.5mm.

This remix provides raised versions from 10mm to 100mm, in 5mm increments.
Measured from the bare metal foot/rod without endcap. 
Files named accordingly.
 

Scaling to precise heights


You can achieve any height in between the 5mm increments by altering only the z-axis height of the model.
Select the model that is smaller but closest to your measure.
Choosing the model close to your actual measure is important to not deform the bevel too much. We strictly want to upscale the model to not make the bevel overhangs harder to print.

E.g., to achieve 42mm height, choose the 40mm raiser version and do the rule of three assuming 40mm being 100%. 

100 / 40 = 2.5
2.5 * 42 = 105

Scale (only) the the z-axis to 105% in this 42mm example.

Print advise

Its a lengthy print and a brim should be used as warp precaution and to not eventually kick the higher than wide model off the plate

Assembly

NOTE, the Ikea system assumes that the protruding fins are being cut thinner by the sharp inner edge of the hollow metal foot rod. This seems to be the case to work around lax tolerances of the inner diameter of the foot. The diameter varied by +/- 0.5mm even on only my 8 table legs i raised.

This effect only works with softer material as you can see when removing your original end-caps.
Observe/measure those original endcaps and grind/sand away an equal amount on your prints to make them fit to each leg perfectly.
 

Tags