Fitbit Charge 6 Charging Stand

I liked the shape of pellcorp's charging stand, but wanted to change the hexagonal cutout on the stand support. I also changed how the wire is routed. The charger itself is held in very simply; you should be able to press fit charger into its cutout, and it should be secured enough to not come out when you remove the fitbit. You may have to scale up or down slightly depending on your printer setup. 

There is a rectangular hole inside the base to add weight to, I used some random pieces of metal I had lying around. If you want to fill this hole with shot, sand, or other things, add a pause at layer 174 (assuming a 0.2 layer height).

If you don't want the stand to slide around, I'd recommend buying a roll of self-adhesive silicone tape, the type you'd use to put on furniture legs. You can get a 4"x40" roll off Amazon for 10 dollars. Ive used this on similar prints I keep on my desks and tables. 

Print flat on its side. Supports are required for the hole the charger seats into; I used tree supports touching the build plate only. Printed initially out of PLA using a 0.4mm nozzle, 0.2mm line width, 0.2mm layer height.