KP3S 3.0 HBV-W202012HD camera mount for Z axis
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
KP3S 3.0 HBV-W202012HD camera mount for Z axis
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 75
- Makes
- 0
- Views
- 508
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a Z axis camera mount for the KP3S 3.0.
This uses the low cost HBV-W202012HD camera module.
Printer: KP3S 3.0
Filament: PLA
Infill: 15% hexagonal
Nozzle: 0.4mm
Layer Height: 0.2mm
Supports: organic, only touching build plate (probably don't need supports…)
Slicer: PrusaSlicer
IF YOU USE THE GCODE FILE (or the PrusaSlicer Project 3mf file?), THERE IS A LOAD BED MESH (M420 S1) COMMAND AFTER THE HOME COMMAND (G28)
To install, first tap the 4 holes with an M3 tap. If the flimsy one breaks, 3 screws should still hold the camera module securely.
Next, remove the two screws holding the Z axis limit switch, and insert them into the two holes on the mount. They might not go into the holes if you mount the camera module first.
Continue to mounting the camera module using 4x (or 3x if you ran into issues…) M3x8 screws (M3x5 would be the smallest you could use, I had 8mm long screws on hand).
Finally, press the Z axis limit switch into the mount, making sure the small screws go into the holes on the switch. it will be quite a tight fit. Make sure you cleaned up any residual support material.
There will be about 1-2mm of threads which is plenty to screw into the original mounting point for the switch.
I bundled the cameras USB cable into the Z axis harness.