1 / 6
XTool P2 Corner Square Guide
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A square to make it easier to position projects on the XTool P2
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 79
- Makes
- 1
- Views
- 591
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
XCS Project: https://www.designfind.com/inspiration/15796
I purchased a honeycomb bed for my X2 P2, but I found it hard to lay out projects and make them square. The laser is not able to reach 0,0 of the project.
To solve this, I created a square that fits in the corner and brings (0,0) into the laser range.
To Use:
- Cut out a square on the laser
- Place the square in the corner of the laser bed
- Apply tape to X-Offset, Y-Offset
- Lable the offset of X,Y to reach (0,0) of the square
- Use plastic panel fasteners to hold the square in place