Iphone 7 plus case

This is a case for the Iphone 7 plus. This case is split into two halves that allows it to be printed on smaller printers and using non-flexible filament like PLA. The original design was made by zlagger.

If you make your shell thickness very thin, then you can choose your case design by choosing the infill pattern.

Update #1: I have fixed the camera on the top portion to allow it to slide in without smashing the camera module on iPhone.

Update #2: I have modified the case into version 2 of the case that makes the bottom large, and the top just an add on piece to lock in the device. This version may have to be slightly trimmed on the snap in pieces because of printer inconsistency.

Update #3: I have gone back to the center connecting piece type design because of how ugly version 2 was. The top piece connector now fits inside of the case to make it lock into place better.

Print Settings

Rafts:

Doesn't Matter

Supports:

**Resolution:**

0.2

Infill:

Notes:

Version 3: Fan settings need to have the cooling fan at 100% speed in order to be able to bridge the overhang on the connector piece.

The more infill you add, the stronger the case is.

Without a raft, the case often tends to warp, but depends on your printer and your settings.

Post-Printing

Assembly Instructions

Category: Electronics