Fritz Repeater AX 1200 Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stand for a Fritz Repeater 1200 AX for freely pointing it into different directions
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 27
- Makes
- 0
- Views
- 311
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This stand allows to fit a Fritz Repeater 1200 AX into it, plug a LAN cable in from the bottom, power from the back and then point it directly where you want the wifi to be.
The model provide enough space around the connector at the back to fit a Aqara smart plug to the repeater to be able to switch it on and off remotely.
The whole model is useful if you want to cover a specific area with a stronger wifi signal and all available outlets are pointing into the wrong direction.
For assembly of this you additionally need:
- 6x M4x20 screws
- 6x M4 nuts
- 6x M4 washers
The base can be assabled with just 4x M4 screws and nuts. To fit the case between the arms, you need to put two washers on the M4 screw first, drive it through the arm, then another washer and finally fit the screw into the nut inside the case. With this configuration the screw will not peek out and block repeater when its going into the case.