Spool Drawer Connector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made these to compliment the pull out drawers for various empty filament spools.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 24
- Makes
- 0
- Views
- 120
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a way to stack my spool organizers and be able to access all 4 drawers.
These were made using measurements from Hatchbox spools, but they should fit another other type as well. I’ll include the dimensions of the print so you can check if they will fit as is.
There is lip near the base of each Connector to allow a small gap between the spools giving them room to spin freely. Each Connector sits inside the one below it to keep it balanced.
- PLA
- .2mm layer height
- Organic/Tree supports (for the Spool Connector)
- 10% infill
Spool Connector Base:
53mm diameter. 68mm tall
Spool Connector:
53mm diameter. 68mm from lip to top.