1 / 4
Starlink Mini 18V RYOBI Battery Power Adapter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It is really easy to power your Starlink Mini with 18V RYOBI batteries.
- Rating
- 5 / 5
- Likes
- 79
- Downloads
- 340
- Makes
- 1
- Views
- 5,602
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
It is really easy to power your Starlink Mini with 18V RYOBI batteries. This will drive the 50' cable that comes with the Mini.
Instructions:
- Print the part
- Put the RYOBI terminals on a 18V battery. Check the polarity. There is a tab on one side. Make sure it aligns with the tab slot in the printed part
- Push the adapter down onto the battery. This should get the clip started into the printed part
- Remove the part/clip and use your thumb to fully seat the clip
- crimp female connectors onto the ends of the pigtail red/black wires
- push connectors onto terminals
- Insert the Starlink Mini cable into the Starlink Mini and into the pigtail connector
- put the adapter onto the RYOBI battery to use
Parts needed:
- 14AWG 5.5mm x 2.1mm DC Female Barrel connector pigtail ( https://amzn.to/3AJsv05 )
- 2M Starlink Mini Cable ( https://amzn.to/3MrQkfr )
- Ryobi 30001044 replacement terminals (
https://www.partswarehouse.com/Ryobi-Contact-Plate-Holder-Assembly-RY-300001044-p/hm-300001044.htm ) - Insulated 1/4" female terminals (https://amzn.to/32hGPIb)
Tools:
- Crimper ( https://amzn.to/3iZzvrl )
- Wire Stripper ( https://amzn.to/3aJLkyV )
FTC Disclaimer: We may earn commissions for purchases made through the links below. As Amazon Associates we earn from qualifying purchases.