1 / 2
Playseat Challenge chonky wheel bracket clamps
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the clamps that connect to the Playseat's frame. Chonkier than the original, they withstand forces better.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 42
- Makes
- 0
- Views
- 492
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This thicker model takes M5 screws and nuts. The nut holes are a bit tight-- use the “screw pulling technique” (insert the screw into the other side of the nut, and tighten the screw to pull in the nut into the holder).
The upper hole in the “ClampAttach” is compatible with the rest of floano's model.
I printed this in PETG, 3 perimeters, 40% infill, 0.2mm layer. Supports aren't necessary if you don't mind a little cleanup work under the arch.