KKSB Case Feet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Feet for the KKSB Raspberry Pi 5 Case. These allow you to stand up the case without it pushing on the power button.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 134
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
The KKSB Case for Raspberry Pi 5 is a great case for the Raspberry Pi and the 7" screen. However I found myself always pressing the power button at the bottom of the case when wanting to sit it down.
These feet provides some elevation to the case and allows you to let the case stand up without pressing the button. They mount using the VESA holes on the back.
Note: The SD card slot will be partially blocked by the foot, so you might have to take it off whenever you want to access the SD card.
Assembly:
You will need 4 M3 screws. As the holes in the model is not threaded it will be a bit harder to screw in the screws the first time.
Printing instructions:
Print with the largest side down (holes facing build plate).
The model in the picture is printed on a Bambu P1S with:
- Filament: Bambu PLA Basic
- Infill: 15%, Gyroid
- Supports: No
- Adhesion: No