1 / 6
Dino-Clip with printed snap-together axles - REMIX — image 1
1 / 6

Dino-Clip with printed snap-together axles - REMIX

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€2.31 – €2.82 net (excluding VAT)

For file: Dino Clip with Printed Axles updated_0.2mm_PLA_MK3S_2h55m.gcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €2.57 excluding VAT (range midpoint).

Weight reported by the author
25 g
Print time reported by the author
2.91 hr
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

Reinforced cam axles by printing axles that snap together. A snug fit all around but inserts fine with a rubber mallet.

Rating
3.5 / 5
Likes
59
Downloads
388
Makes
2
Views
3,038
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Print the dino-clip in place without supports.  Print two sets of axles for each hole with supports.  Works great at 0.2mm.  Set Infill to any percentage, I am using 20%.

Works best to insert both outer axle pieces at the same time or do the lower cam piece first to avoid bending and breaking outer arms.  Start inserting each outer axle piece into each hole until it just holds, flip over dino-clip and either lean on it with bodyweight or use a rubber mallet to evenly insert axles.  The outer axle will insert until flush with the opposite axle arm.  Then, pinch the inner axle piece and insert it into the outer axle hole.  It seems to work well to align the gap with the long width of the outer axle opening, but either way should work.

I tried to illustrate assembly with photographs.

I found it works best to not use supports on Dino-Clip but it does leave a little stringing in the hole that can be cleaned up before assembly (UPDATED: Stringing removed with modification).

UPDATED: Modified the models to remove stringing and for a snugger fit of the smaller axle insert piece.

Sneaks' markings are left in place without modification.

Tags