Counting matching models…
The ellipse widens the bladder and causes it to be better ventilated and thus dry faster. The formation of bad odors is reduced and can thus extend the life of the bladder. The ellipse was designed for the use with a 2 liter water bladder…
The model consists of - 1x left wall - 1x right wall - 3x connecting rods Dimensions can height: 110 mm - 115 mm diameter: 74mm Printing information - Printed in PLA - No supports are needed. - The left and right walls fill the entire…
Practical travel case for a safety razor. Four magnets prevent the case from opening accidentally. In the bottom of the case is space for several spare blades. The case was printed in place on a Prusa MK3S+ in PLA and ABS. No supports…
I used the holder with the Raspberry Pi wide-angle lens with a focal length of 6 mm. See technical drawing for exact dimensions. Print PLA 0.2 mm layer height printed as four pieces joint 2 w/ support 20% infill Additional material M2x 8…
The key chain is designed to permanently embed a round RFID tag (diameter 25mm) during the printing process. The print must be paused at a specific layer so the RFID tag can be placed into the opening, after which printing is resumed to…
Case for a C14 electrical socket (type AC-08). See technical drawing for dimensions. Print settings PLA 0.2 mm layer height 3 parts w/o supports Additional material M3 x 8 mm with hex-nuts (6x) M2 x 8 mm with hex-nuts (1x) Drill 2 mm wood…
A small holder to fix a lamp power cord to the ceiling with a screw. It was designed for a power cord with a diameter of of 6 mm. The screw hole has a diameter of 5 mm. To print the holder without supports, the screw hole in the upper…
Sledding at night is a great experience. In poorly lit sections, a headlight is helpful. The common models such as the Tikkina Petzl can hardly be attached to the helmet and quickly slip away. This adapter prevents the lamp from slipping…
These are all currently available results.
