P
Printablesmichalzielanski
OpenRC F1 Servo Saver Connector for TSS-10HM
OpenRC F1 Servo Saver Connector for Turnigy™ TSS-10HM/TSS-10MG Micro Servo.
- Downloads
- 275
- Likes
- 34
- Rating
- 5
All models
Counting matching models…
P
Printablesmichalzielanski
OpenRC F1 2017 - Steering limiter
The limiters prevent rotation of the servo saver's by more than 31 degrees to the left/right. They should be glued to the Front Lower BOM.
- Downloads
- 202
- Likes
- 22
- Rating
- 5
P
Printablesmichalzielanski
PS2 joysticks case
Case for two joysticks from Chinese shopping platforms. Joysticks are typically used with development boards such as Arduino, micro:bit, ESP32, Raspberry Pi.
- Downloads
- 46
- Likes
- 7
- Rating
- 0
P
Printablesmichalzielanski
Accu-Chek Spirit Combo Clip Case - clip spare part
The handle clip on my insulin pump broke. I tried to glue it back together but it broke again so I created and printed a replacement part that works like the original one. The part should be printed with a layer height of 0.1 mm, the…
- Downloads
- 44
- Likes
- 3
- Rating
- 0
P
Printablesmichalzielanski
PolyDryer Box Spool Holder, Ball Bearing Axle, Shaft
Filament holder for the Polymaker PolyDryer container using 6904-2RS bearings (20×37×9 mm). Inspired by the holder created by Clough42 and its later remixes by LencoSolutions , Eric Keiffer , and MakingMedicalPhysics , I decided to create…
- Downloads
- 20
- Likes
- 9
- Rating
- 5
P
Printablesmichalzielanski
Microbit Game Controller Case Ants Make AM-044
This is a case for a micro:bit expansion board. These boards aren't precision-made, so yours may be slightly different. I'm providing step files for easy customization.
- Downloads
- 13
- Likes
- 1
- Rating
- 0
P
Printablesmichalzielanski
RC Cramer 4x4 Belt Mod axle for Metal Mod
This is a modification that allows you to use Mod Correa Cramer together with Mod Metal Cramer .
- Downloads
- 11
- Likes
- 4
- Rating
- 0
P
Printablesmichalzielanski
TS100 3x tip holder
Remix insert allowing storage of 3 additional soldering iron tips. I recommend printing with PETG filament.
- Downloads
- 9
- Likes
- 0
- Rating
- 0
These are all currently available results.