Counting matching models…
Most cell phone camera tripod mounts are WAY too complicated. Like trying to kill a gnat with a sledgehammer. And most limit you you to one cell phone type or manufacturer. This is a very simple universal mount. It requires no extra…
This is a simple pin hinge. Yes, I noticed it is square, and yes... it will still fit a 3mm hole. This hinge is primarily for foam models, although it will work in balsa too. The "pin" part of the hinges I usually make use very small…
Simple and very light wing mount servo box for a EMax ES 9051 4 gram servo. The servo is not glued in, it is a press fit and doesn't move. Glue the box in the wing, install the servo, screw on the lid and done. Takes #2 3/16" screws.…
These are trimmers used to trim a controlled and even edge on RC model covering, both plastic (Monocote, et al) and tissue. The double edge version works best as most single edged blades nowadays are pretty much crap. They arrive dull and…
This is a very lightweight servo mount for dual 3.7 gram micro servos. These are fairly generic servos and anything listed as "3.7g" should fit. These are a snap fit but shown is 1/4" #2 screws holding them in. The mount is meant to be…
This is a small hose clamp made to connect standard 1/8" ID aquarium airline vinyl hose to a 1/8" barb fitting. I make RC aircraft and do a lot of vacuum bagging. My normal pulls are in the range of about 22 to 24 inches of mercury and…
Lightweight servo box for mounting in wings. Left and right versions. The servo boxes are glued to the wing and the servos themselves are a press fit, no adhesive required. Easily changed if a servo fails. Print Settings Printer:…
Simple flour scoop requires no support. No holes to make washing difficult. Print with 3 walls, 10% infill, 2 bottom layers and 4 top layers for best cosmetic look. Print Settings Printer: ANET A-8 Rafts: No Supports: No Resolution: .2mm…
Lightweight (2.5 grams) box to hold aileron servos in a wing panel. The servos need no screws or glue, they are held in place in the box. There is a right and left version to account for wire leads. There is also a right and left top…
The Monoprice Maker Select V2 is a rebranded Wanhao Duplicator 3 and they are not terrible printers for the price although nowadays there are much better choices. It was the first printer I bought quite a while ago. However, they share a…
These are mounting boxes to mount small 5 gram Hextronik or TowerPro (they are the same) servos in a wing. There is a left and right version included, including a lid that attaches with #1 screws. The servo is a push-in fit, no need to…
These are all currently available results.
