Counting matching models…
Because the other looms were to small for my girlfriend to make a Frog, I designed an larger loom. It fits just on a Leapfrog Creatr. Update 04-06-15: Girlfriend tried the loom and had some comments. The top was too sharp so I rounded the…
2020-07-09: I needed a VESA mount for my raspberry pi 4 which has this heatsink installed: https://shop.pimoroni.com/products/aluminium-heatsink-case-for-raspberry-pi-4?variant=31116595888211 However I thought it would be nice to just be…
Somehow the vibration damper from https://www.thingiverse.com/thing:1707045 didn't fit snugly around the feet of the Prusa I3 MK2, so I drew a simple damper which has a bit large fit for the feet. They do an awesome job dampening the…
Print the model with 0.2 mm layerheight and set all infill to cocentric. best to print with 100% infill and in PETG
Clean and simple businesscard holder to place onto your desk and show off your impressive collection of businesscards ;) Made to fit a 85x55 mm card (room for 90x60 mm). If you have any comments to improve the design please let me know.…
bought a second hand Miele c1 complete vacuum that didn't come with a false air clip on the vacuum hose. So it would suck in false air constantly. I modelled and printed a new one. I found others on here that were not suitable for this…
UPDATE 2024-07-08: Added a 25 mm desk thickness model. ========== Created originally for a HyperX Stinger but works also for every other headphone. I was annoyed my headphones were cluttering my desk. I Wanted to keep a radius in the…
Simple phone holder for your bike modified to fit bookcase type phone cover
5.5 mm shaft fits in 6 mm holder. Wheel is 25.8 mm in diameter for the widest dimension. Print it as rough as you like on the side of the pin. Works without supports but will probably give a rough surface on one side of the wheel, however…
Somewhat organic remote holder for smartwares (SH4-99580AT). Made to be as minimal as possible. You can stick a piece of 2-sided tape on the back and never lose your remote again!
Update 23-03-2024: Added a new type of holder with the same working as the rest of the design. It allows for min 6 mm and max. 16 mm stip pencils. It allows you to use any diameter in this range. It can also be screwed on the tripod with…
Adapter for airconditioner hose of 125 mm diameter. Print without supports. Made to fit into a +/- 127 mm hole or larger. Can be screwed into the wall with 6 times 4 mm diameter screws. If you would like to see other dimensions please…
Modelled a soap dish! Printed in wood pla filament and have been using it for a year now. Seems to hold up fine.
I bought the IKEA visbäck poster holder but found it was not attached sturdy enough to the wall as is it fell down when my kid pointed to something on the poster. The hole on the backside is quite big which is hard for a nail or screw to…
The knob for my blender broke and the company did not react to my request for a spare. So I modeled one. Print it with the hole for the pin on your print plate and use (organic)supports for the best result.
A sliding bracket for wall installment of the slide case rev 3 using screws (or you know just stick tape under them.) https://www.prusaprinters.org/prints/2243-arduino-mega-2560-rev3-slide-case-rflink Print instructions Print with low…
These are all currently available results.
