Stip/Dot center tool
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stip center tool to allow you to put a dot right in the middle of your round or square plate/bowl to be painted.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 23
- Makes
- 0
- Views
- 257
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Update 23-03-2024:
Added a new type of holder with the same working as the rest of the design. It allows for min 6 mm and max. 16 mm stip pencils. It allows you to use any diameter in this range. It can also be screwed on the tripod with the same screws and in the same holes.
-------------------
Assembly
Install all parts with 3x 12 mm screws.
1. put a 608 bearing in the cross (or not, I'm not your mom!)
2. screw cross on top of bottom using "NEW DOP"
3. slide all 4 studs in simultaneous. Use some silicone/PTFE spray to make it go smooth.
4. use at least 1 end piece (but preferably more) to close the end of the cross. Clamp it down in between two legs of the cross where the holes are.
5. Install the tripod using 3 screws.
6. Install the holder using 3 screws.
7. Install Rev2Holder_Rails using 2 screws on top of the tripod.
8. Install Rev2Holder_pin 3x in the rails.
9. Install Rev2Holder_disc on the Rev2Holder_Rails. It is click fit, just push as hard as you can.
Tuning
1. Install the smallest stip pen possible.
2. Loosen the screws from the holder.
3. Shift the holder to put the pen precisely in the middle of the screw.
All done! Enjoy stipping/dotting!