Counting matching models…
Need a way to express yourself? Having trouble getting to 37 pieces of flair? Add this kick stand foot for extra flair! The diameter of the hole is approx 25mm. The slit in side of shaft/hole and printing in TPU helps give some…
Remix of https://www.printables.com/model/30496-very-printable-strap-adjuster by @Zenfunk, with ideas from @gloda: Added slot so it can be attached to closed strap loops (without re-stitching). Added fuzzy skin to the bar making contact…
As with original, for best result you should print with no infill and added walls until solid fill. I also ironed the topmost layer, for aesthetics (makes it look flatter). The base is only required for stacking (e.g. if 2 or more high).…
Update 2025-08-18: Added a high-res version, for a print with more detail. Update 2025-03-27: v2: Better angle on the foot and cleaned up mesh. Mix of shaft/hole with model of a foot* Fitted to 12x11mm “tear-shaped” stand (see photos).…
Ringosaurus with a back
Uses the Belfry OpenScad Library, v2.0 (BOSL2). See here to download and for installation instructions: https://github.com/BelfrySCAD/BOSL2/ You can use Openscad and change the variables to match the size of hose/pipe you have. After the…
Update 2026-06-13: Added an adapted model for a shelf (hangs perpendicular to the edge). Will work for shelves up to 13mm thick. Inspired by Made to screw-clamp onto a desk, and added extra hook at the bottom. Designed for a desktop 25mm…
Print with supports at 45 degrees relative to the bed for best results. Made with Openscad.
Replacement foot for IKEA Tuffing bunkbed. If the fit is slightly loose, you can use a few windings of electrical tape to make a snug fit.
Printed 0.12mm layer height for detailed lettering. Add filament change at the height when lettering starts to print in two colours. For Bambulabs printer without AMS, use custom filament change G-code such as this:…
For bolthead size, see image. For strength: In your slicer, add cylinder modifier through the centre with wall loops increased to 5 (see images).
I tried both horizontal and vertical orientation. Vertical orientation was strong enough, with less support material and less to clean up post-print. Printed with ‘extra fine’ layer height (0.08mm) in PETG with a 0.4mm nozzle.
Bike frame is round with 20mm diameter. Inside of kickstand is 30mm high (chord length) and the chord height is approx 3.4mm. Step file included so you can make adaptions. Printed in 95A TPU which handles weather and has a little bit of…
These are all currently available results.
