Counting matching models…
I printed this holder to place the remote on the wall. the holder fits tighty the remote and do not need any magnet to stay in place. However, an hole DN10mm by 1,6mm has been place to place one round magnet if needed. The holder is…
Nothing special about it. Holes are little bit tight, but just enought to avoid free movements. Could be printed in PETG, PLA according to your needs.
I did a case to place into my bag back and avoid to damage it. the case is designed to let the additionnal antenna in place. 2 holes are on each side and could be used as screw cases. you just have to print a lid. Print Settings Printer…
It is an holder for nano GM10 GPS from Flywoo designed for AOS 3.5 frame. Installed in front just above camera. Works fine and no issue at all when crashing, the holder is soft but just enought to keep the GPS in place. Print Settings…
The original spool holder on the SV01 is a simple small axis, and occasionally, the filament unwinding process isn't very smooth. While there are various designs available for replacement online, I decided to create my own version. Some…
STL are to build a case for ESP8266 combined with OLED display 128X34. I use with pulse flowmeter for water consumption. Here the link : *ESP8266 V3 :…
I made five ceiling lights for above my kitchen counter. They're built using DN50 PVC pipes. I DIY-ed the mounts in white PLA, keeping them low-key. I 3D printed wire guides to center the tubes perfectly straight. The mounts have threads,…
simple support for DJI O3 antenna + ELRS place on vertical polarization Category: R/C Vehicles
for processing, nothing special compared to orginal work done by Alex
I did not found so much support for ZOHD DART XL with O3 airunit. then I designed mine which is lightweight, based on existing front plate. I glued it , and fine tune the camera hole to allow up and down tilt. 2 holes have been done on…
my beeper was tighten with zip tie, but I designed an holder to attache it with the 2 screws placed in front of frame. probably heavier than Zip tie, but also less jerky. Print Settings Printer Brand: Sovol 3D Printer: Sovol SV01PRO…
Very simple holder for a small IR remote. Printed in PLA, and placed with double tap Nothing special. Category: Household
All parts could be printed without any support according to your printer and set-up. Rail support and Tube holder can be attached with M5 screw and bolt. The bulb holder has not been designed and not shown on the 3D cut view. according to…
I modified my Zorro radio by replacing the original antenna with an external one. However, the nut securing the connector is located inside the radio housing, making it very difficult to properly tighten or loosen when switching antennas.…
These are all currently available results.
