Counting matching models…
I needed a case for a Raspberry Pi 3 Model B+ which I was planning on using to create a Flightradar24 tracking station. The Pi required an RTL-SDR dongle and a Flightaware 1090MHz ADS-B filter to also be connected so I decided to try and…
I knocked up this little mount so I could attach a little Hawkeye Little Pilot 3.5" monitor onto my TX16S Transmitter. It has a stepped 3mm mount hole (so you can use small washers if required) and uses an M4 bolt and nut to clamp it to…
After fitting my Ender-3 Pro with a Micro Swiss direct drive I found that the cables were floating around at the extruder end. I came up with the idea of printing a clip to attach to the extruder stepper motor that the conduit could be…
Designed to contain an Arduino Uno with an OpenEnergyMonitor EmonTX Shield mounted. The shield is connected to the primary power inlet for the house which allows me to monitor the overall power consumption for the property. The shield…
I knocked up this little mount so I could attach a little Hawkeye Little Pilot 3.5" monitor onto my Spektrum DX6i transmitter. It has a stepped 3mm mount hole (so you can use small washers if required) and uses an M4 bolt and nut to clamp…
These are all currently available results.
