Counting matching models…
Original credit goes to @URSPB. Printed in 0.3mm layer height at 15% infill and 2 outside walls. The original openscad file is very easy to edit. Make sure to measure the inside radii of your wrenches well to ensure a good fit--a couple…
I modeled a basic gridfinity tray with three slots to hold some nail punches that didn't have a dedicated space. I added holes which press-fit magnets and hole the punches in even upside down, though I recommend adding an additional set…
This imperial drill bit holder (1/2" - 1/16") uses the gridfinity standard base and houses all of my spare bits that I don't often use. I was constrained to a 4x3 footprint by the space I wanted to put this organizer, hence the tight…
My daughter broke the pin that held the two pieces which made up the pliers in her black and decker kids toolbox. This piece should print quickly at 0.2mm layer height with 15% infill. It just press fits in.
The latch on my daughter's play toolbox was missing when we bought it second-hand so I modeled a replacement. This design prints in two pieces. The larger of the two needs supports under the small cylinders which clip into the smaller…
Designed with direct inspiration from @decay3d, this ghost is assembled using a mechanical keyboard switch. I used some old Akko linear switches but clicky switches would sound even better. Place the switch into the lower housing and then…
These are all currently available results.
